Thread Starter
Powerflex 753 Fault Code List
Hello everyone,
We are using a Powerflex 753 VFD to control a motor which lifts and descends loads. The drive goes into fault code 12 (HW Overcurrent) and code 36 (SW Overcurrent) multiple times while its descent in the loaded condition. The drive does not go into fault when:
1. It ascends or descends in no load.
2. Ascends in load condition.
Therefore the fault occurs only in one direction under loaded condition.
I have google searched and tried changing a few parameters [Parameter 43 (Flux Up Enable) and Parameter 44 (Flux Up Time), Parameter 70 (Autotune) and Parameter 621 (Slip RPM at FLA) to 0], but it didn't affect the faults.
Any ideas why? Any solutions?
We are using a Powerflex 753 VFD to control a motor which lifts and descends loads. The drive goes into fault code 12 (HW Overcurrent) and code 36 (SW Overcurrent) multiple times while its descent in the loaded condition. The drive does not go into fault when:
1. It ascends or descends in no load.
2. Ascends in load condition.
Therefore the fault occurs only in one direction under loaded condition.
I have google searched and tried changing a few parameters [Parameter 43 (Flux Up Enable) and Parameter 44 (Flux Up Time), Parameter 70 (Autotune) and Parameter 621 (Slip RPM at FLA) to 0], but it didn't affect the faults.
Any ideas why? Any solutions?
Thread Starter
Powerflex 753 Allen Bradley Drive Manual
Hello everyone,
We are using a Powerflex 753 VFD to control a motor which lifts and descends loads. The drive goes into fault code 12 (HW Overcurrent) and code 36 (SW Overcurrent) multiple times while its descent in the loaded condition. The drive does not go into fault when:
1. It ascends or descends in no load.
2. Ascends in load condition.
Therefore the fault occurs only in one direction under loaded condition.
I have google searched and tried changing a few parameters [Parameter 43 (Flux Up Enable) and Parameter 44 (Flux Up Time), Parameter 70 (Autotune) and Parameter 621 (Slip RPM at FLA) to 0], but it didn't affect the faults.
Any ideas why? Any solutions?
We are using a Powerflex 753 VFD to control a motor which lifts and descends loads. The drive goes into fault code 12 (HW Overcurrent) and code 36 (SW Overcurrent) multiple times while its descent in the loaded condition. The drive does not go into fault when:
1. It ascends or descends in no load.
2. Ascends in load condition.
Therefore the fault occurs only in one direction under loaded condition.
I have google searched and tried changing a few parameters [Parameter 43 (Flux Up Enable) and Parameter 44 (Flux Up Time), Parameter 70 (Autotune) and Parameter 621 (Slip RPM at FLA) to 0], but it didn't affect the faults.
Any ideas why? Any solutions?
Powerflex Fault Codes
Fault 926 is listed as an 'Ethernet fault'. Famous marathi lavani songs list punjabi. Limewire linux free download. Check your Ethernet connections. Is the Ethernet routed near any power wiring for long distances? This can be a drive interface card problem- but not likely in two drives. A 'cave man reset' (cycling the power) is the only way to reset this. Drive as; drive, PowerFlex 400 or PowerFlex 400 Drive. Avs video converter 9.1 full version. Parameter numbers and names are shown in this format:. The following words are used throughout the manual to describe an action: Drive Frame Sizes Similar PowerFlex 400 drive sizes are grouped into frame sizes to simplify spare parts ordering, dimensioning, etc.